Heater & Furnace Repair & Installation

Airquest Heating and Air provides:

Ongoing training and updates for our staff to provide you the utmost service
Fully insured technicians
Properly stocked trucks
On-Time Focus
Up-Front Pricing
Parts and Labor warranties
Airquest Heating and Air is proud to be staffed with the best heating repair technicians. Each specialist at Airquest Heating and Air has the expertise and skills to maintain, diagnose, and correct problems throughout the heating system.

Our on-going training allows our technicians to correctly adjust system controls to recommended settings and test the performance of the entire system using specialized tools and test equipment. We want to make sure your system is up and running so that you and your family are well taken care of. Please see our maintenance checklist to see our repair process in more detail.

Furnace Tune-Up, Cleaning and Safety Inspection



Keep Your Furnace at Peak Efficiency with an Annual Tune-Up and Safeguard your Family with a FREE Carbon Monoxide Test.

Airquest Heating and Air trained technicians will perform a 30-60 minute precision tune-up and professional cleaning including the following 20 operations
  1. Carbon Monoxide - test air flow duct system for dangerous carbon monoxide
  2. Thermostat - test for proper operation, calibrate and level
  3. Inspect for combustible material around furnace
  4. Ignition System - test for safe and proper operation
  5. Exhaust System - test for proper venting
  6. Measure Supply/Return temperature differential
  7. Safety & Control Circuits - test for proper operation
  8. Inspect and adjust fan belt tension (if applicable)
  9. Clean or replace existing air filter
  10. Lubricate and clean blower motor air vents
  11. Furnace Burner - clean and inspect (brush and vacuum)
  12. Heat Exchangers - clean and inspect (brush and vacuum)
  13. Clean furnace exterior
  14. Video scope of heat exchangers for dangerous cracks and wear
  15. Gas Pressure - measure and adjust for peak efficiency
  16. Lubricate all moving parts per manufacture
  17. Blower Motor - measure amperage and voltage for proper operation
  18. Electrical Wiring - inspect and tighten connections
  19. Combustion Vents - clean and inspect (upper and lower)
  20. Natural Gas - check for leaks